Volume 15Issue 4
Jul. 2022
Turn off MathJax
Article Contents
ZHANG Yu-qi, KAN Qiang, ZHAO Jia. Electrostatic discharge failure characteristics of oxide vertical cavity surface emitting lasers[J]. Chinese Optics, 2022, 15(4): 722-730. doi: 10.37188/CO.2021-0226
Citation: ZHANG Yu-qi, KAN Qiang, ZHAO Jia. Electrostatic discharge failure characteristics of oxide vertical cavity surface emitting lasers[J].Chinese Optics, 2022, 15(4): 722-730.doi:10.37188/CO.2021-0226

Electrostatic discharge failure characteristics of oxide vertical cavity surface emitting lasers

doi:10.37188/CO.2021-0226
Funds:Supported by Nano Special Project of National Key Research and Development Program (No. 2018YFA0209001); National Key Research and Development Project (No. 2018YFA0209002, No. 2018YFB2200700)
More Information
  • Corresponding author:zhaojia@sdu.edu.cn
  • Received Date:20 Dec 2021
  • Accepted Date:23 Mar 2022
  • Rev Recd Date:24 Jan 2022
  • Available Online:27 Apr 2022
  • Oxide Vertical Cavity Surface-Emitting Lasers (VCSELs) are widely used in data communication. However, VCSELs are sensitive to ElectroStatic Discharge (ESD), which is one of the main reasons for their failure. It is difficult to identify the root cause of this problem. Therefore, 3 different ESD models including Human Body Model (HBM), Machine Model (MM) and Charge Device Model (CDM) and Electrical OverStress (EOS) shocks were applied to carry out the failure analysis of oxide VCSELs. Among them, voltage shocks of different polarities were used for HBM while reverse I-V, forward L-I-V scan, emission microscopy (EMMI) and Transmission Electron Microscopy (TEM) were used for characterization. The results show that different ESD models show significantly different damage voltage thresholds, and the oxide VCSEL is susceptible to damage in the HBM and MM models but insensitive in the CDM model. Defect characteristics associated with ESD failure were found including increased reverse leakage, degradation of optical output power, and bright spots in the EMMI. TEM was the most direct and effective method where different ESD events showed different defect sizes and locations. These research results are of great significance to confirm whether the failure mode is caused by ESD and to judge the specific ESD models in detail.

  • loading
  • [1]
    张继业, 李雪, 张建伟, 等. 垂直腔面发射 器研究进展[J]. 发光学报,2020,41(12):1443-1459. doi:10.37188/CJL.20200339

    ZHANG J Y, LI X, ZHANG J W, et al. Research progress of vertical-cavity surface-emitting laser[J]. Chinese Journal of Luminescence, 2020, 41(12): 1443-1459. (in Chinese) doi:10.37188/CJL.20200339
    [2]
    杨卓凯, 田思聪, LARISCH G, 等. 基于PAM4调制的高速垂直腔面发射 器研究进展[J]. 发光学报,2020,41(4):399-413. doi:10.3788/fgxb20204104.0399

    YANG ZH K, TIAN S C, LARISCH G, et al. High-speed vertical-cavity surface-emitting lasers based on PAM4 modulation[J]. Chinese Journal of Luminescence, 2020, 41(4): 399-413. (in Chinese) doi:10.3788/fgxb20204104.0399
    [3]
    何晓颖, 董建, 胡帅, 等. 采用BCB平整技术的高速850nm垂直面发射 器[J]. 中国光学,2018,11(2):190-197. doi:10.3788/co.20181102.0190

    HE X Y, DONG J, HU SH, et al. High-speed 850 nm vertical-cavity surface-emitting lasers with BCB planarization technique[J]. Chinese Optics, 2018, 11(2): 190-197. (in Chinese) doi:10.3788/co.20181102.0190
    [4]
    张玉岐, 左致远, 阚强, 等. 氧化型垂直腔面发射 器的常见失效模式和机理分析[J]. 中国光学,2022,15(2):187-209. doi:10.37188/CO.EN.2021-0012

    ZHANG Y Q, ZUO ZH Y, KAN Q, et al. Common failure modes and mechanisms in oxide vertical cavity surface emitting lasers[J]. Chinese Optics, 2022, 15(2): 187-209. (in Chinese) doi:10.37188/CO.EN.2021-0012
    [5]
    HELMS C J, AEBY I, LUO W L, et al. Reliability of oxide VCSELs at Emcore[J]. Proceedings of SPIE, 2004, 5364: 183-189. doi:10.1117/12.539282
    [6]
    KRUEGER J J, SABHARWAL R, MCHUGO S A, et al. Studies of ESD-related failure patterns of Agilent oxide VCSELs[J]. Proceedings of SPIE, 2003, 4994: 162-172. doi:10.1117/12.482632
    [7]
    张建华, 陈章福, 徐小雪, 等. 人体静电放电对有机发光二极管的影响[J]. 发光学报,2018,39(2):169-174. doi:10.3788/fgxb20183902.0169

    ZHANG J H, CHEN ZH F, XU X X, et al. Analysis of organic light emitting diode under electrostatic discharge stresses[J]. Chinese Journal of Luminescence, 2018, 39(2): 169-174. (in Chinese) doi:10.3788/fgxb20183902.0169
    [8]
    UEDA O. Reliability and degradation of III-V optical devices focusing on gradual degradation[M]//UEDA O, PEARTON S J. Materials and Reliability Handbook for Semiconductor Optical and Electron Devices. New York, NY: Springer, 2013: 87-122.
    [9]
    HSU C L, DAS S, WU Y S, et al. Spectrally resolved optical beam-induced current imaging of ESD induced defects on VCSELs[J]. OSA Continuum, 2021, 4(2): 711-719. doi:10.1364/OSAC.414086
    [10]
    VANZI M, MURA G, MARCELLO G, et al. ESD tests on 850 nm GaAs-based VCSELs[J]. Microelectronics Reliability, 2016, 64: 617-622. doi:10.1016/j.microrel.2016.07.023
    [11]
    MCHUGO S A, KRISHNAN A, KRUEGER J J, et al. Characterization of failure mechanisms for oxide VCSELs[J]. Proceedings of SPIE, 2003, 4994: 55-66. doi:10.1117/12.482637
    [12]
    MATHES D, GUENTER J, TATUM J, et al. AOC moving forward: the impact of materials behavior[J]. Proceedings of SPIE, 2006, 6132: 613203. doi:10.1117/12.646447
    [13]
    GUENTER J K, TATUM J A, HAWTHORNE III R A, et al. VCSELs at Honeywell: the story continues[J]. Proceedings of SPIE, 2004, 5364: 34-46. doi:10.1117/12.540129
    [14]
    WEIDBERG A R. VCSEL reliability in ATLAS and development of robust arrays[J]. Journal of Instrumentation, 2012, 7: C01098.
    [15]
    MATHES D T, GUENTER J, HAWKINS B, et al.. An atlas of ESD failure signatures in vertical cavity surface emitting lasers[C]. Proceedings of ISTFA, ISTFA, 2005: 330-336.
    [16]
    UEDA O, HERRICK R W. Failure analysis of semiconductor optical devices[M]//UEDA O, PEARTON S J. Materials and Reliability Handbook for Semiconductor Optical and Electron Devices. New York: Springer, 2013: 19-53.
    [17]
    MOKHTARI M, PAGNOD-ROSSIAUX P, LEVALLOIS C, et al. Mechanical strain mapping of GaAs based VCSELs[J]. Applied Physics Letters, 2021, 118(9): 091102. doi:10.1063/5.0040386
    [18]
    MUKHERJEE K. Materials science of defects in GaAs-based semiconductor lasers[M]//HERRICK R W, UEDA O. Reliability of Semiconductor Lasers and Optoelectronic Devices. Amsterdam: Elsevier, 2021: 113-176.
    [19]
    GUENTER J K, TATUM J A, HAWTHORNE III R A, et al. A plot twist: the continuing story of VCSELs at AOC[J]. Proceedings of SPIE, 2005, 5737: 20-34. doi:10.1117/12.601831
    [20]
    HUANG J J SH, JAN Y H, CHANG H S, et al. .ESD polarity effect study of monolithic, integrated DFB-EAM EML for 100/400G optical networks[C]. Proceedings of 2017 Conference on Lasers and Electro-optics Pacific Rim, IEEE, 2017: 1-4.
    [21]
    HUANG J S. Reliability of optoelectronics[M]//SWINGLER J. Reliability Characterisation of Electrical and Electronic Systems. Cambridge: Woodhead Publishing, 2015: 83-114.
    [22]
    HUANG J SH, OLSON T, ISIP E. Human-body-model electrostatic-discharge and electrical-overstress studies of buried-heterostructure semiconductor lasers[J]. IEEE Transactions on Device and Materials Reliability, 2007, 7(3): 453-461. doi:10.1109/TDMR.2007.907425
    [23]
    TWU Y, CHENG L S, CHU S N G, et al. Semiconductor laser damage due to human-body-model electrostatic discharge[J]. Journal of Applied Physics, 1993, 74(3): 1510-1520. doi:10.1063/1.354850
    [24]
    MEIER H, SANTSCHI R, ODERMATT S, et al. A TCAD approach to robust ESD design in oxide-confined VCSELs[J]. Proceedings of SPIE, 2007, 6484: 648405. doi:10.1117/12.698997
  • 加载中

Catalog

    通讯作者:陈斌, bchen63@163.com
    • 1.

      沈阳化工大学材料科学与工程学院 沈阳 110142

    1. 本站搜索
    2. 百度学术搜索
    3. 万方数据库搜索
    4. CNKI搜索

    Figures(7)/Tables(1)

    Article views(598) PDF downloads(161) Cited by()
    Proportional views

    /

    Return
    Return
      Baidu
      map